Page 1
USER'S MANUAL Model No. IKTL73130 Serial No. Serial Number Decal QUESTIONS? If you have questions, or if there are missing or damaged parts, we will guarantee complete sat- isfaction through direct assis- tance from our factory. TO AVOID DELAYS, PLEASE CALL DIRECT TO OUR TOLL- FREE CUSTOMER HOT LINE.
IMPORTANT PRECAUTIONS WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons, read the following important precautions and information before operating the treadmill. 1. It is the responsibility of the owner to ensure 11. If an extension cord is needed, use only a 3- that all users of this treadmill are adequately conductor, 1mm (14-gauge) cord that is no...
Page 4
20. When using iFIT.com CDs and videos, an 23. Inspect and properly tighten all parts of the electronic “chirping” sound will alert you treadmill regularly. when the speed of the treadmill is about to 24. Never insert any object into any opening. change.
And when you’re not exercising, the calling. The model number of the treadmill is unique 760 treadmill can be folded up, requiring less IKTL73130. The serial number can be found on a than half the floor space of other treadmills.
ASSEMBLY Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials except for the packing materials around the brackets on the uprights (see step 1). Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-perfor- mance lubricant.
Page 7
2. Insert one of the Extension Legs (92) into the Upright Base (97). Make sure that the decal is in the indicated location. Insert the other Extension Leg (92) in the same way. Decal With the help of a second person, carefully tip the tread- mill so the Upright Base (97) is flat on the floor.
Page 8
5. The box inside of the Pulse Bar (71) fits into a cavity in Pulse Wire the pulse bar bottom; orient the pulse bar bottom so the box is inside of the cavity. Attach the pulse bar bottom with eight 3/4” Screws (108). Tighten the Screws indi- cated by the arrows first, and tighten the center Screws last.
Page 9
8. Set the Console Base (101) on the Uprights (29, 30). Insert any wires into the Uprights. Thread four 4” Bolts (76) with four 1/4” Silver Star Washers (77) into the Uprights and the Console Base. Be careful not to pinch the Wires (not shown) in the Uprights.
HOW TO USE THE CHEST PULSE SENSOR HOW TO PUT ON THE CHEST PULSE SENSOR dried. If the chest pulse sensor is not dried after each use, it may remain activated longer than nec- The chest pulse sensor consists of two components: essary, draining the battery prematurely.
Page 11
TREADMILL OPERATION THE PERFORMANT LUBE WALKING BELT Your treadmill features a walking belt coated with PERFORMANT LUBE , a high-performance lubricant. IMPOR- TANT: Never apply silicone spray or other substances to the walking belt or the walking platform. Such substances will deteriorate the walking belt and cause excessive wear. HOW TO PLUG IN THE POWER CORD Socket on treadmill This product must be grounded.
Page 12
Clip Note: If there are thin sheets of clear plastic on the console, remove them. FEATURES OF THE CONSOLE iFIT.com CD and video programs ( iFIT.com CDs and videocassettes are available separately). iFIT.com CD The treadmill console offers an impressive array of and video programs automatically control the speed features that help you get the most from your workouts.
Page 13
buttons. Each time a HOW TO TURN ON THE POWER button is pressed, the speed setting will change by 0.1 mph; if a Plug in the power cord (see page 11). button is held down, the speed setting will change in increments of 0.5 mph. To change the Locate the on/off speed setting quickly, press the Quick Speed but- switch near the power...
Page 14
To change the unit of Measure your heart rate if desired. measurement, first hold down the Stop button You can measure your heart rate using either the while inserting the key handgrip pulse sensor or the chest pulse sensor. into the console. An “E” for English miles or an To use the hand- “M”...
Page 15
The speed setting for the HOW TO USE PRESET PROGRAMS Current Segment first segment is shown in the flashing Current Segment column of the Insert the key fully into the console. matrix. (The incline set- tings are not shown in See HOW TO TURN ON THE POWER on page the matrix.) The speed settings for the next...
Page 16
To stop the program temporarily, press the Stop HOW TO USE HEART RATE PROGRAMS button. The Time/Pace display will begin to flash. To restart the program, press the Start button or the Speed button. To end the program, press CAUTION: the Stop button, remove the key, and then reinsert If you have heart prob- the key.
Page 17
During heart rate pro- automatically increase or decrease to bring your grams, the matrix will heart rate closer to the target heart rate. If the show a graphic that speed reaches the maximum speed setting of the represents your heart program (see step 4 at the left) and your heart rate.
Page 18
HOW TO CONNECT YOUR PORTABLE STEREO HOW TO CONNECT THE TREADMILL TO YOUR CD PLAYER, VCR, OR COMPUTER Note: If your stereo has an RCA-type AUDIO OUT jack, see instruction A below. If your stereo has a 3.5mm LINE OUT jack, see instruction B. If your To use iFIT.com CDs, the treadmill must be connected stereo has only a PHONES jack, see instruction C.
Page 19
HOW TO CONNECT YOUR HOME STEREO HOW TO CONNECT YOUR COMPUTER Note: If your stereo has an unused LINE OUT jack, Note: If your computer has a 3.5mm LINE OUT jack, see instruction A below. If the LINE OUT jack is see instruction A.
Page 20
HOW TO CONNECT YOUR VCR HOW TO USE IFIT.COM CD AND VIDEO PROGRAMS Note: If your VCR has an unused AUDIO OUT jack, see instruction A below. If the AUDIO OUT jack is being used, see instruction B. If you have a TV To use iFIT.com CDs or videocassettes, the treadmill with a built-in VCR, see instruction B.
Page 21
• Make sure that the audio cable is properly If the speed or incline settings are too high or too low, you can manually override the settings at any connected, that it is fully plugged in, and that it is not wrapped around a power cord. time by pressing the Speed or Incline buttons on the console.
Page 22
Hold the handrails, step onto the walking belt, and HOW TO USE PROGRAMS DIRECTLY FROM begin walking. During the program, an electronic OUR WEB SITE “chirping” sound will alert you when the speed and/or incline of the treadmill is about to change. CAUTION: Always listen for the “chirp”...
Page 23
THE INFORMATION MODE/DEMO MODE IMPORTANT: The Calories/Pulse display should be blank. If a “d” ap- The console features an information mode that keeps track of the total number of hours that the treadmill has pears in the display, the con- been operated and the total number of miles that the sole is in the “demo”...
HOW TO FOLD AND MOVE THE TREADMILL HOW TO FOLD THE TREADMILL FOR STORAGE Before folding the treadmill, adjust the incline to the lowest position. If this is not done, the treadmill may be per- manently damaged. Next, unplug the power cord. CAUTION: You must be able to safely lift 45 pounds (20 kg) to raise, lower, or move the treadmill.
Page 25
HOW TO LOWER THE TREADMILL FOR USE 1. Hold the upper end of the treadmill with your right hand. Pull the latch knob to the left and hold it. Pivot the treadmill down until the frame is past the latch pin. Engaged Frame Latch Knob...
TROUBLESHOOTING Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department toll- free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays). PROBLEM: The power does not turn on SOLUTION: a.
Page 27
With the help of a second person, carefully raise the Uprights (29, 30) to the position shown. Carefully pivot the Hood (105) off. Locate the Reed Switch (22) and the Magnet (19) on the left side of the Pulley (18). Turn the Pulley until the Magnet is aligned with the Reed Switch.
Page 28
PROBLEM: The incline of the treadmill does not change correctly or does not change when iFIT.com CDs and videos are played SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re- move the key.
CONDITIONING GUIDELINES ergy. Only after the first few minutes does your body WARNING: begin to use stored fat calories for energy. If your goal Before beginning this is to burn fat, adjust the speed and incline of the tread- or any exercise program, consult your physi- mill until your heart rate is near the lowest number in cian.
Page 30
SUGGESTED STRETCHES The correct form for several basic stretches is shown at the right. Move slowly as you stretch—never bounce. 1. Toe Touch Stretch Stand with your knees bent slightly and slowly bend forward from your hips. Allow your back and shoulders to relax as you reach down toward your toes as far as possible.
PART LIST—Model No. IKTL73130 R0104A To locate the parts listed below, see the EXPLODED DRAWING attached in the center of this manual. No. Qty. Description No. Qty. Description No. Qty. Description Left Foot Rail 3/4” Tek Screw Silver Ground Screw Foot Rail Screw Belly Pan Clip Key Clip...
Page 34
• The MODEL NUMBER of the product (IKTL73130) • The NAME of the product (IMAGE 760 treadmill) ® • The SERIAL NUMBER of the product (see the front cover of this manual) • The KEY NUMBER AND DESCRIPTION OF THE PART(S) (see the EXPLODED DRAWING and PART LIST...