Epic Fitness A30e Elliptical Manual page 14

14. Have a second person hold the Console (7) near
the Console Bracket (62).
Connect the Ground Wire (119) to the matching
wire on the Console (7). Then, insert all of the
wires on the Console downward through the
indicated hole in the Console Bracket (62).
Tip: Avoid pinching the wires. Attach the
Console (7) to the Console Bracket (62) with four
M4 x 16mm Screws (104).
Untie and discard the wire tie (not shown) on the
Main Wire Harness (110).
See the inset drawing. Connect the Main Wire
Harness (110) and the two indicated wires to the
matching wires on the Console (7). Make sure
to connect the wire that has a tag to the wire
on the Console that has a tag.
15. Note: For clarity, the Console and the wiring
are not shown in this step.
Tip: It may be necessary to turn the
Console Knob (52) and adjust the angle of
the Console Bracket (62).
Attach the Upper Handlebar Cover (56) to the
Right and Left Handlebars (83, 87) and to the
Console Bracket (62) with three M4 x 16mm
Screws (104); start all three Screws, and then
tighten them.
Make sure that the wiring (not shown) is
inside the Upper Handlebar Cover (56).
Then, press the Lower Handlebar Cover (60)
onto the Upper Handlebar Cover (56).
14
7
Hole
15
52
104
60
14
Avoid pinching
the wires
119
62
104
104
7
Wires
56
104
62
87
83
110