Operating Instructions; Turning The Tester On/Off; Auto Power Off; Disabling The Beeper - Fluke 1AC II VoltAlert Instruction Sheet

Operating Instructions

Turning the Tester On
Momentarily press the green button. Listen for a double beep to confirm activation. A
continual VoltBeat flash visually indicates the Tester is active.
Turning the Tester Off
Press and hold the green button for more than half a second. Listen for a long half-
second beep to confirm deactivation of the Tester. The absence of the VoltBeat flash
indicates the Tester is inactive.
VoltBeat (System Self-Test)
VoltBeat is a self-test feature for visual confirmation of battery and system integrity, and
power on. It provides a double-flash every two seconds during normal operation.
Checking for the Presence of AC Voltage
Placing the tip of the unit near an ac voltage produces a steady glow at the tip and, if
enabled, a continual beep.

Auto Power Off

After about five minutes of non-use, the Tester automatically powers off to save battery
life. A double beep, followed by a longer, single beep, provides audible indication
that the Tester has powered off. The absence of the VoltBeat flash serves as a visual
power-off indication.

Disabling the Beeper

Disable the beeper by holding the green button down for more than two seconds during
power up. To enable the beeper again, turn the Tester off, and then turn it on.

Low Battery Indication

When the battery voltage drops below two volts, VoltBeat provides visual indication by
stopping the VoltBeat flash. Replace with two AAA (LR3) batteries.
Cleaning
Clean with damp cloth.

Contacting Fluke

●
Technical Support USA: 1-800-44-FLUKE (1-800-443-5853)
● Calibration/Repair USA: 1-888-99-FLUKE (1-888-993-5853)
● Canada: 1-800-36-FLUKE (1-800-363-5853)
● Anywhere in the world: +1-425-446-5500
Or, visit Fluke's website at www.fluke.com.
To register your product, visit http://register.fluke.com.
To view, print, or download the latest manual supplement, visit
http://us.fluke.com/usen/support/manuals.

LIMITED WARRANTY AND LIMITATION OF LIABILITY

This Fluke product will be free from defects in material and workmanship for two years
from the date of purchase. This warranty does not cover fuses, disposable batteries,
or damage from accident, neglect, misuse, alteration, contamination, or abnormal
conditions of operation or handling. Resellers are not authorized to extend any other
warranty on Fluke's behalf. To obtain service during the warranty period, contact your
nearest Fluke authorized service center to obtain return authorization information, then
send the product to that Service Center with a description of the problem.
THIS WARRANTY IS YOUR ONLY REMEDY. NO OTHER WARRANTIES, SUCH AS
FITNESS FOR A PARTICULAR PURPOSE, ARE EXPRESSED OR IMPLIED. FLUKE
IS NOT LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL OR CONSEQUENTIAL
DAMAGES OR LOSSES, ARISING FROM ANY CAUSE OR THEORY. Since some
states or countries do not allow the exclusion or limitation of an implied warranty or of
incidental or consequential damages, this limitation of liability may not apply to you.
Fluke Corporation
P.O. Box 9090
Everett, WA 98206-9090
U.S.A.
11/99
Fluke Europe B.V.
P.O. Box 1186
5602 BD Eindhoven
The Netherlands