Pyle PLD96MU Manual page 20

6,03/( 7528%/( 6+227,1* *8,'(
352%/(06 &$86(6 62/87,216
No power
- Check and make sure the connecting wires are connected correctly
- Check whether the fuse is blown. Replace with the proper value fuse if necessary.
No sound
- Check and make sure the speaker wires are connected correctly.
No picture
- Check whether the video wire is connected to the video device.
Unit hand-up
- Press the RESET button to reset the unit to its default stage.
No function when pressing the buttons
- Press the RESET button to reset the unit to its default stage.
Poor effect or unable to receive radio
- Check whether the radio antenna is inserted or properly connected.
- Antenna may not be the proper length. Make sure the antenna is fully extended.
- Antenna may be poorly grounded. Check and make sure the antenna is properly grounded.
Stereo cannot be received under radio mode
- Tune the radio frequency accurately.
- The broadcasting signal is too week, set the mode to MONO.
Disc inserted but cannot play
- Check whether the disc inserted upside down.
- Check whether the disc is dirty or badly cracked.
- Lens is dirty. Clean lens by using the lens clean disc.
Picture without colour or no sound under disc/USB/SD/MMC playback mode
- Improper setting of colour system. Set again to "PAL" or "NTSC".
- The disc is dirty or damaged. Wipe the disc with a dry soft cloth or replace a new disc.
Abnormal moving, skipping or sound during playback
- The disc is dirty or damaged. Wipe the disc with a dry soft cloth or replace a new disc.
Remote handset does not work
- Replace new battery of the remote handset.
- Point the remote handset directly at the remote sensor of the main unit.
- Clean the surface of the remote sensor.
Note
After the above efforts, if the unit still cannot be worked normally, consult your service
dealer. Never attempt to disassemble the unit by yourself. No service part inside the unit.
19 IB-B049-0006-00