Installation - Boss Audio Systems MR1440U User Manual

12. PRESET STATION MEMORY AND TOP/>||, INT, RPT, RDM BUTTONS
a) During radio mode:
Go to any preset station by pressing one of the 6 preset station buttons (1-6).
If one of these buttons is pressed for more than 2 seconds, the station currently
being listened to will be memorized into the selected preset button.
b) During disc, SD/MMC or USB mode:
1) Press the TOP/ >|| button briefly to interrupt the playback of the disc, SD/MMC
or USB. Press again to resume normal playback of the disc, SD/MMC or USB.
Press the TOP/>|| button and hold for approximately 0.5 seconds to play the
first track of the disc, SD/MMC or USB.
2) Press the INT button to sample the first 10 seconds part of each track, and the
INT ON will be visible on the LCD display.
In the process of INT, pressINT button again to stop sampling and to continue
playing the current track, and the LCD will display INT OFF.
3) Press the RPT button once to play the current track repeatedly, and the RPT
ONE will be visible on the LCD display.
During MP3/WMA disc, SD/MMC or USB mode, press the RPT button twice
continuously to play the current folder repeatedly, and the RPT ABM will be
visible on the LCD display.
In the process of RPT, press RPT button again to stop playing repeatedly
mode and the LCD will display RPT OFF.
4) Press the RDM button to play all tracks on disc in random order, and the RDM
ON will be visible on the LCD display.
In the process of RDM, press RDM button again to stop playing in random
order and the LCD will display RDM OFF.
c) During the normal playback of MP3/WMA disc, SD, MMC,USB:
Press the radio preset button 6 and 5 to move up and down10 tracks at a time.
13. ST/MO BUTTON
In FM mode, press the ST briefly to select stereo or mono sound mode.
14. LOUDNESS BUTTON
When press shortly, the LOUD mode is turned on, its to enhance the bass sound
effect when the volume level is low. Press again to cancel the loudness effect.
15. LOC/DX BUTTON
Radio station search mode is divided by this LOC/DX switch, this button can
be used to control an attenuator in the tuner during search.
In radio mode, press the LOC button to change local reception or distance
reception. Local mode improves reception in some areas where the signal
is too strong.
Note: This button is only for FM reception. In AM mode, LOC is void.
16. CLOCK BUTTON
Press the CLK button briefly to display time for 5 seconds on the display, and
then returns to its previous display unless the button is pressed again.
Then press the CLK button and hold for more than 1 second until the real time
flashes on the display. Then you can adjust HOUR or MINUTE by rotating the
VOL knob.
PDF created with FinePrint pdfFactory trial version
Page 5
http://www.pdffactory.com

INSTALLATION

INSTALLATION METHOD
This is an anti-theft installation method.
The main unit wears a METAL MOUNTING SLEEVE.
Please connect the wiring, eg, the Power Supply, the Speakers and the Antenna
according to the requirements of this Instruction Manual, then install the metal
mounting sleeve into the car as per the diagram illustrated below.
To boost up the capability of anti-jamming,
METAL SUPPORT STRAP
please make sure fix tightly the
strap into the metal joint that connect to the
chassis of the car.
DASHBOARD
METAL MOUNTING SLEEVE
To remove the unit out of the metal mounting sleeve,
insert the two supplied KEYS into the left and right side
slots of the chassis at the same time. Then pull the chassis
out of the metal mounting sleeve as shown in the right
illustration.
NOTE
Before mounting and operating
the CD player, remove the metal
mounting sleeve illustrated by the
arrow s.
Push this reset button with a cuspidal
object to renovate the distorted program
once the program is distorted.
metal support
Bend the tabs on the metal mounting
sleeve against the DASHBOARD with
a screwdriver.
UNIT CHASSIS
PLASTIC TRIM RING
FRONT PANEL
Remove the two screws that
fix the CD deck mechanism player
during transportation before
mounting the player.
EJECT KEY
RESET BUTTON
Page 10