Chapter 5: Using The Universal Remote Control53; Programming The Universal Remote Control - Gateway XHD3000 User Manual

Programming the universal
remote control
You can program the remote control directly (by entering a
five-digit code) or by browsing codes.
To directly program the remote control with a code:
1
2
To program the remote control by browsing through the
most common codes:
1
2
54
CHAPTER 5: Using the Universal Remote Control
Press and hold the mode button (CBL/SAT, DVD, LCD, or
MEDIA CENTER) for the device you want to program for
about four seconds. The LED flashes twice, indicating
that the button is ready to be programmed.
Press the five-digit code for the device. After the code is
entered, the LED flashes twice, indicating that
programming is complete.
If an invalid key or code is entered, or if ten seconds
passes without a button press, programming mode ends
and the previous values are restored. The LED lights for
about a half second, then turns off.
Press and hold the mode button (CBL/SAT, DVD, LCD, or
MEDIA CENTER) for the device you want to program for
about four seconds. The LED flashes twice, indicating
that the button is ready to be programmed.
Press 991, then press the digit that corresponds to the
type of device you want to associate with that mode's
button:
Device type
LCD
DVD
CBL/SAT
Media Center
Tuner
The remote is temporarily programmed with the first
most common code for the selected device type.
Digit
0
1
2
3
4