Installation Instructions; Grounding The Refrigerator - GE 36" Built-In Bottom-Freezer Installation Instructions Manual

36" built-in bottom-freezer refrigerators
Hide thumbs Also See for 36" Built-In Bottom-Freezer:
Table of Contents

Advertisement

Installation
Instructions
TOOLS
REQUIRED
, Tinsnips to cut banding
o Stepladder
Bucket
Level
Appliance Hand Truck
Tubing cutter
7/16" open-end wrench
#2 Phillips screwdriver
Drill and appropriate bits
5/!6", 7/16" socket
, Safety glasses
,1-1/4"
open end wrench
o Pliers
,1/4"
ratchet
HARDWARE SUPPLIED
, Water filter bypass plug
Anti-Tip brackets
!/4" nut and ferrule
MATERIALS REQUIRED
o 35" long 2x4 for Anti-Tip support
,1/4"
copper water line tubing or GE SmartConnect"
Refrigerator Tubing kits
, Water shut-off valve
, Custom panels for fresh food door, freezer drawer
and grille panel
Screws to secure refrigerator to cabinetry.
o Stick-on hook and loop fastener strips for
1/4" side panels
FLOORING
For proper installation, this refrigerator must be placed
on a level surface of hard material that is at the same
height as the rest of the flooring. This surface should
be strong enough to support a fully loaded refrigerator,
or approximately 1,200 Ibs.
NOTE: Protect the finish of the flooring. Cut a large
section of the cardboard carton and place under the
refrigerator where you are working.
GROUNDING
THE REFRIGERATOR
IIPORTANT--{Please reed carefully)
FOR PERSONAL SAFETY,THIS APPLIANCE MUST BE
PROPERLYGROUNDED.
The power cord of this appliance is equipped with
a ]-prong (grounding) plug which mates with a
standard three-prong (grounding) wall receptacle
to minimize the possibility of electric shock hazard
from this appliance.
Have the wall outlet and circuit checked by a
qualified electrician to make sure the outlet is
properly grounded.
Where a standard 2-prong wall outlet is encountered, it
is your personal responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
DO NOT, UNDER ANY
CIRCUMSTANCES, CUT
OR REMOVE THE THIRD
(GROUND) PRONG FROM
THE POWER CORD.
DO NOT USE AN ADAPTER PLUG TO CONNECT THE
REFRIGERATORTO A 2-PRONG OUTLET.
DO NOT USE AN EXTENSION CORD WITH THIS
APPLIANCE.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Monogram series

Table of Contents