Panel Dimensions - GE 36" Built-In Bottom-Freezer Installation Instructions Manual

Design Guide
1/4" FRAMED PANEL DIMENSIONS
If you choose to install framed panels, they must be cut
to the dimensions shown. The panels will slide into the
frame on the door, drawer and grille.
If the custom panel is less than 1/4" thick and if it fits
loosely in the door frame, it can be backed up with a
piece of filler material or foam tape to improve the fit.
Door
\
\
\
1_5/16"
Trim
Reveal
_,1/4"
Panel
I_A I
[ Grille Panel _
Fresh Food
_
Panel
I
Freezer Drawer D
Panel
IMPORTANT NOTE: Maximum total
panel weight:
• Fresh food door panel - 58 Ibs.
• Freezer drawer panel - 28 Ibs.
• Grille Panel - 11 Ibs.
Framed Panel Dimensions
A (Width) B (Grille Height) C (FF Height)
1/4" Framed Panel 33-7/8" 8-7/8" 46-1/16"
D (FZ Height)
21-7/8"
Overlay Panel Dimensions
A (Width) B (Grille Height) C (FF Height)
1/4" Backer Panel 33-7/8" 8-7/8" 46-1/16"
0.10" Spacer Panel 32-1/2" 7-5/8" 44-11/16"
3/4" Overlay Panel 34-1/8" 9" 46-5/16"
D (FZ Height)
21-7/8"
20-1/2"
22"
3/4" OVERLAY PANEL DIMENSIONS
For a more custom appearance, overlay panels may be
installed on trimmed models. The overlay panel must be
secured to a 1/4" thick backer panel which slides into the
trim. A spacer panel 0.10" thick must be placed between
the overlay and backer panel.
Assemble the panels with glue and screws.
, Center the spacer panel on the backer panel, left to
right and top to bottom. Secure the panels with glue.
, Center the spacer and backer panel on the overlay
panel and secure with glue and screws. Screws must
be countersunk into the backer panel.
Door/Drawer
\
\
i
t
1'/4"
Backer
Panel
_Spacer
IMPORTANT NOTE: Maximum
total weight for the assembled
panels:
• Fresh food door panel - 58 Ibs.
• Freezer drawer panel - 28 Ibs.
• Grille Panel - 11 Ibs.
NOTE: Left-to-right offset is not alwags equal to
top-to-bottom offset.