Step 8, Adjust Door Swing; Step 9, Install Grille Panel - GE 36" Built-In Bottom-Freezer Installation Instructions Manual

Installation Instructions
[STEP 8 lAD JUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fullu to 130 °, Uou may change the door swing to a 90 °
opening. Skip this step if door opening is satisfactory
for gour instelletion situetion.
• Lift the grille panel to access the wire cover trim.
• Remove screws on both sides of the wire cover trim
and lift oft
• Use pliers to unscrew door stop and reinstall into the
90 ° position.
L_
Remove
Wire Cover
Trim Screws
F
J
PinLocationFor
90° Door_
Pin Location
as Shipped
130° Door Swing
• Reinstall the wire cover trim.
INSTALL GRILLE PANEL
• Raise the grille panel to stop position.
I
Loosen !
Side ,
Trim
Screw
GrilleJ|_
, --_ Panne/_
AdjustNut Below
Springto Accommodate
Panel W eight
Loosen
Side
Trim
Screw
• Loose screws on side trim behind frame. Remove
bottom trim.
• Slide panel over the metal backer panel and into
the trim.
• If necessaru, tap with a wood block until panel slips
under the top trim piece.
• Reassemble bottom trim. Tighten screws.
• Adjust the hinge spring to accommodate the panel
weight, if necessaru.
13