Connecting The Display - Planar PT1700M(U) User Manual

Connecting the display

To configure this monitor, please refer to the following figure and
procedures.
1. Be sure all equipment is off.
2. Connect the DC power cord to the power connector. Plug one end of the
AC power cord into the power adapter, and the other end into an electrical
outlet(1).
3. For the PC with Analog graphics output: connect the VGA signal cable from
display VGA input connector to the 15-pin connector of your host computer
and tighten the screws(2).
4. WARNING For PT1700(1)MU Monitor: Do not connect the USB cable from USB
port of your display to the USB port of your computer until the touch screen
software driver has been installed.
5. After driver installation for PT1700(1)MU : Re-connect the USB cable from USB
port of your display to the USB port of your computer.
6. Turn on your computer, display and video source.
Notice: Notice:
Notice: Notice: To ensure the LCD display works well with your computer, configure Notice:
the display mode of your graphic card, less than or equal to 1280 x
1024 resolution and make sure the timing of the display mode is
compatible with the LCD panel. "Compatibility Modes" of this LCD
panel are listed in the appendices for your reference.
12
PT1700M(U) and PT1701M(U) User's Guide (
(Figure 1.1 and Figure 1.2) (Figure 1.1 and Figure 1.2) (Figure 1.1 and Figure 1.2)
(Figure 1.1 and Figure 1.2) (Figure 1.1 and Figure 1.2)
020-0410-00 A)