Replacing V-Belts - Grizzly G0746 Owner's Manual

3. adjust the hex nuts on the motor mount bolts
(see figure 135) until there is approximately
⁄ " deflection in each V-belt when it is pushed
3
4
with moderate pressure.
Motor Mount
hex Nuts & Bolts
Deflection
figure 135. adjusting V-belt tension.
4.
Firmly tighten the hex nuts to secure the set-
ting, then re-install the motor access panel
and close the end-gear cover.
-82-
Pulley
⁄ "
3
4
Pulley

Replacing v-belts

Tools Needed:
slotted screwdriver #2 ...................................... 1
open End Wrench 10mm .................................. 1
1.
disCoNNECt lathE FroM poWEr!
2.
open the end-gear cover and remove the
motor access panel (see figure 134 on page
81).
3.
adjust the hex nuts on the motor mount bolts
(see figure 135 to raise the motor, then
remove the V-belts.
4.
install the new V-belts as a matched set so
they equally share the load.
5. tension the V-belts. (refer to Tensioning
v-belts on page 81.)
6.
re-install the end-gear cover and motor
access panel.
Model G0746/G0749 (Mfg. Since 3/13)
Qty