Table of Contents
Advertisement
2.
read and follow the safety instructions at the
beginning of the manual, take all required
safety precautions, and make sure all pre-
vious preparation steps discussed in this
manual have been followed and completed.
3.
Clear away all tools and objects used during
assembly, lubrication, and preparation.
4.
Make sure that the chuck and jaws, if installed,
are secure.
Note: If a chuck is not installed on the lathe,
you do not need to install one for this test.
5.
push the EMErgENCy stop button on the
control panel (see figure 26), and point the
coolant nozzle into the chip pan.
EMErgENCy
Cutting Fluid
stop
pump switch
Button
figure 26. Control panel buttons used in test
Note: In the next step, you may need to rock the
chuck back and forth as you make the adjust-
ments, so that the gears will mesh together.
Model G0746/G0749 (Mfg. Since 3/13)
power
lamp
run.
6.
set the spindle speed to 24 rpM as follows:
a. position the spindle range lever straight
up, so it aligns with the arrow on the
headstock (see figure 27).
spindle range
lever
Spindle
Range Lever
Pointing Up
figure 27. spindle speed set to 24 rpM.
b. position the spindle speed lever so the
"E" is directly under the black arrow on
the headstock (see figure 27).
7.
Make sure the spindle lever is in the middle
(oFF) position to prevent unexpected startup
when power is enabled (see figure 28).
spindle
lever
figure 28. spindle lever in middle (oFF)
position.
8.
turn the main power switch oN and reset
the EMErgENCy stop button by twisting
it clockwise until it pops out. the power lamp
on the control panel should illuminate.
spindle
speed lever
Spindle Speed
Lever Set To
"E" (24 RPM)
E
-29-
Advertisement
Table of Contents
