Garmin GPSMAP 190-01230-10 Owner's Manual page 39

From the Home screen, select
Engine.
Cycling Through Engine Gauge Screens
1. From the Home screen, select
Engine.
2. Select the left and right arrows on the
gauge screen to the next.
Customizing Engine Gauge Limits
To establish the upper and lower limits of a gauge and the range
of desired standard operation, you can configure up to four values
for the engine gauge. When a value exceeds the range of standard
operation, the gauge face or bar becomes red.
Setting Description
Scale This value is less than the rated minimum, and it represents
minimum the lower limit of the gauge. This setting is not available on all
gauges.
Scale This value is greater than the rated maximum, and it represents
maximum the upper limit of the gauge. This setting is not available on all
gauges.
Rated Represents the minimum value of the standard operating range.
minimum
Rated Represents the maximum value of the standard operating
maximum range.
1. From the Home screen, select
Engine > MENU > Gauge Setup
GPSMAP 400/500 Series Owner's Manual
Information > Dashboard >
Information > Dashboard >
Rocker to move from one
Information > Dashboard >
> Set Gauge Limits.
2. Select a gauge.
3. Select Gauge Limits > Custom.
4. Select the gauge limit you want to set (Scale Min, Scale Max,
Rated Min, or Rated Max).
NOTE: Some of these options may not be available for all
gauges.
5. Select the gauge limit.
6. Repeat steps 4 and 5 to set additional gauge limits.
Activating Status Alarms for Engine Gauges
If you have activated gauge status alarms, when the engine sends
a warning status message over the NMEA 2000 network, a gauge
status alarm message appears. The gauge face or bar may become
red depending on the alarm type.
From the Home screen, select
Engine > MENU > Gauge Setup
Customizing Engine Gauge Status Alarms
1. From the Home screen, select
Engine > MENU > Gauge Setup
2. Select one or more engine gauge alarms that you want to turn on
or off.
3. Select Back.
Viewing Information
Information > Dashboard >
> Status Alarms > On.
Information > Dashboard >
> Status Alarms > Custom.