Vehicle.installation - Garmin Quest 2 Owner's Manual

G s > V I
ettInG tarted ehIcle nstallatIon
Vehicle Installation
You can install and store the Quest 2 in the vehicle mount. The
Quest 2 runs off power from your vehicle when the ignition is
turned on. Be sure the vehicle ignition is turned off before you
install or remove the unit from the mount.
To install the Quest 2 in the mount:
1.. Flip.up.the.GPS.antenna.to.a.90°.angle.on.the.back.of.the.
Quest.2.
2.. Insert.the.bottom.of.the.Quest.2.into.the.bottom.of.the.
mount, as shown. The antenna fits through the opening in
the.back.of.the.mount.
3.. Snap.the.Quest.2.back.into.the.mount.so.that.it.is.fully.
seated.

To.remove.the.Quest.2,.push.the.tab.
up.and.pull.the.Quest.2.forward.
nOtE: Make sure the tabs are located and locked correctly.
To remove and store the Quest 2:
1.. Push.the.tab.up.that.holds.the.Quest.2.in.place.(see.above).
2.. Pull.the.Quest.2.forward.and.then.out.of.the.mount.
Tab
Quest 2 Owner's Manual
®