Appendix; Using The Remote Control; Updating The Software And Map Data - Garmin GVN 52 Owner's Manual

A
PPENDIX
A

Using the Remote Control

The remote control uses two AAA batteries. Do not mix
old and new batteries together. If the remote does not
work, install fresh batteries. If this does not correct the
problem, you can re-pair the remote control with the
GVN 52. You must also follow this procedure to use a
replacement remote control.
To pair your remote with the GVN 52:
1. Press and hold the Thumb Stick
the remote for 10 seconds.
2. A prompt appears. Select
Yes.
3. Follow the instructions
on the screen; enter the
correct numbers on each
screen. The remote control pairs with the GVN 52.
40
PPENDIX
and the 0 key on

Updating the Software and Map Data

To update the navigation system software, you must
have an SD card, an SD card reader, and an Internet
connection.
To update the navigation software:
1. Go to www.garmin.com/support/download.jsp.
Updates and Downloads.
2. Click Download next to the navigation system software.
3. Read and agree to the terms. Click Download.
4. Select Save. Then save the update onto an SD card.
5. Insert the SD card into the side of the GVN 52. Make
sure the system is powered on. Your software is updated
automatically.
You can purchase map data updates from Garmin. Check
www.garmin.com/unlock/update.jsp
for your map software is available.
Select
to see if an update
RiverPark GVN 52 Owner's Manual