Related Manuals for EverFocus ECMD200
Summary of Contents for EverFocus ECMD200
- Page 1 Covert Color Camera in Working PIR Motion Detector Case Operation Instructions Model No. ECMD200...
- Page 2 OVERVIEW The ECMD200 is a working PIR motion detector with a hidden color camera which utilizes a Sony 1/3” Super HAD II CCD Sensor and advanced DSP solution for excellent light sensitivity. providing well defined color and B/W video for surveillance applications. The PIR sensor can be connected to an alarm system, light control, recording device or other application.
-
Page 3: Package Contents
FEATURES Camera: Color camera with SONY 1/3” Super HAD II CCD sensor Employs Digital Signal Processor (DSP) chip-set for high quality images High Resolution over 600TVL High sensitivity, low smear, high anti-blooming and high S/N ratio for high performance video. Built-in functions: Auto Electronic Shutter (AES), Auto Gain Control (AGC), Auto Trace White Balance (ATW) Digital Wide Dynamic Range (DWDR), 2D Noise Reduction (2DNR). - Page 4 DIMENSIONS...
-
Page 5: Specifications
SPECIFICATIONS Camera ECMD200 Model SONY 1/3’’ Super HAD II Color CCD Image Pick-up Device NTSC: 768*494 Effective Picture Elements 600 TV lines Horizontal Resolution 0.05LUX @ F2.0 Minimum Illumination More than 52 dB S/N Ratio NTSC:1/60s~1/100,000s, PAL:1/50s~1/110,000s Auto Electronic Shutter 0.45... -
Page 6: Installation
INSTALLATION Warning: To prevent electrical shock, turn off the electrical power before making electrical connections. 1. Locate the desired mounting location; position housing with PIR detector and camera pointed generally in the desired direction and mark location. 2. Select hole locations for direct installation or bracket mount installation. Drill pilot holes and insert plastic anchors into holes after drilling. - Page 7 4. If not using the bracket provided (not recommended), attach the PIR detector back cover to the mounting surface with the screws provided (Do not over tighten the screws). If corner mounting the unit, drill a hole ~3/16” diameter in each edge, just below the motion detector PCB.
- Page 8 PIR DETECTOR CONFIGURATION 1. LED Selector: A) Top+Center w/black jumper:- testing mode: Light Blinking B) Center+Low w/black jumper: Normal detection mode: No light blinking while detecting (3 PINS: Top, Center, Bottom) 2. Sensitivity Adjustment: 1. To raise sensitivity turn clockwise 2.
-
Page 9: Output Terminals
5. Pulse Control: Position 1: Set to "ONCE" for instant reaction when PIR Once or twice detects movement, the connected device/alarm will be triggered immediately. PULSE Position 2: Triggering will start after the PIR detects movement twice within 15 seconds. 4 PINS 2 PAIRS w/Jumper connector 6. -
Page 10: Everfocus Electronics Corp
EverFocus USA - California: EverFocus USA - New York: 1801 Highland Avenue, Unit A, Duarte, CA 91010, 415 Oser Avenue, Unit S, Hauppauge, NY 11788, USA TEL: +1 631 436 5070 TEL: +1 626 844 8888...