Table of Contents
Advertisement
SPECIFICATIONS
Model
Image Pick-up Device
Effective Picture Elements
Horizontal Resolution
Minimum Illumination
S/N Ratio
Auto Electronic Shutter
Gamma Characteristic
Lens Furnished
Gain Control
White Balance
Digital Wide Dynamic Range
2D Noise Reduction
Synchronous System
Video Output
Operating Temperature
Humidity
Power Requirements (camera
only)
PIR Detection Angle
PIR Detection Range
PIR N.C/N.O Relay Output
PIR N.C/N.O Alarm Time
Case Open Tamper Switch
Power Supply (separate from
Camera)
Dimensions
Weight
Camera
ECMD200
SONY 1/3'' Super HAD II Color CCD
NTSC: 768*494
600 TV lines
0.05LUX @ F2.0
More than 52 dB
NTSC:1/60s~1/100,000s, PAL:1/50s~1/110,000s
0.45
Pinhole lens 3.7mm / F2.0
Automatic
ATW (2,000°K~10,500°K)
DWDR ON
2DNR ON
Internal
BNC-F; 1 V p-p Composite Video / 75 ohm
-10°C to 50°C (14°F to 122°F)
20%~ 80% non-condensing
12VDC regulated; 100mA
PIR Motion Detector
Horizontal = 100° / Vertical = 45°
10m
2A @ 24 AC/DC
Adjustable from 2 to 40 sec.
Built-in switch; trips alarm relay once if PIR case is opened.
Relay operation on switch activation is same as if a PIR
motion alarm is detected: single relay event as per VR2/J4
settings. This is NOT a separate 'day zone' or '24 hour
zone' type independent/continuous tamper output.
DC 12V; Standby current: 1mA; Working current: 25mA
Overall Mechanical
4.72 x 2.76 x 1.89 inches
130 g / 0.29 lbs
4
Advertisement
Table of Contents
