Garmin GPSMAP 276C Owner's Manual page 118

A > lorAn td s
PPendIx etuP
To set up Loran TD from the Main Menu:
1. Highlight the Setup tab on the Main Menu, and then highlight
the Location sub tab.
2. Highlight the Location Format field, and press ENTER.
Location Sub Tab
3. Highlight Loran TD, and press ENTER.
4. Highlight the Setup button located on the right side of the
Location Format field, and press ENTER. The Loran TD
Setup window appears.
5. To change the settings of any of the five fields, highlight the
field, press ENTER, select a setting using the ROCKER, and
press ENTER again.
110
LORAN TD Setup
6. When finished, highlight the Save button, and press ENTER.
If the active GRI Chain, secondary stations, or offsets were changed
since the waypoint was created, the waypoint now references
the active GRI chain and secondary stations and adjust the TD
coordinates accordingly. Remember that the GPS is not relying
on the LORAN signal for navigation and actually converts the
TD coordinate to a useful latitude and longitude coordinate before
storing the waypoint to memory or using it for navigation. Because
of this, the unit can navigate to a TD coordinate anywhere in the
world.
You must know your GRI chain number and secondary stations
to create a LORAN TD position. For more information, read our
LORAN TD Position Format Handbook, available at the Garmin
Web site, at www.garmin.com/support/userManual.html.
GPSMAP 276C Owner's Manual