Cord Assembly; Handle Assembly - Kenmore 116.33912 Owner's Manual

WARNING
Electrical Shock Hazard
Do not plug into the electrical sup-
ply until the assembly is complete.
Failure to do so could result in elec-
trical shock or injury.
Before assembling vacuum, check the
PACKING LIST on the cover of the separate
Repair Parts List. Use this list to verify that
you have received all the components of
your new Kenmore vacuum.
Remove tape from dust bin latch.
HANDLE ASSEMBLY
Remove the two (2) handle screws located
in the body
Position the handle as shown in the illustra-
tion below
When installing the handle, firmly press the
Handle
Screw_,
Handle
Screw
Electrical_ I
Connection _'_ _l_._,_ Tape
handle onto the body. Secure with handle
screws provided,
Do not overtighten.
Overtightening could strip the
screw holes.
Do not operate the cleaner with-
out the screws in place.
CORD ASSEMBLY
Make sure the quick release upper cord
hook is in the upright position. Remove
the wire tie from the power cord.
Make sure the
power cord is
placed into the lock-
ing notch on the
body as shown. This
helps keep the
power cord out from
under the vacuum
cleaner agitator.
Power
Quick Release
Hook
Wrap the power cord around the upper and
lower cord hooks and lock the power cord
plug onto the power cord.
5