Troubleshooting - DeLonghi ESAM4 Manual

2
4
5
3
4
3
5
6
LIGHts
4
5
4
6
7
5
6
5
7
8
6
7
6
8
9
7
8
7
9
10
8
9
8
10
11
9
10
9
11
10
11
10
11
11

tRoUBLesHootInG

Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PRoBLeM
The coffee is not hot
The coffee is weak or
not creamy enough.
The coffee is delivered
too slowly or a drop at
a time.
DescRIPtIon
The lights flash
alternately
The lights flash
The light is on
steadily
The light flashes
The lights flash
alternately
PossIBLe cAUse
• The cups were not preheated.
• The infuser has cooled down because
2/3 minutes have elapsed since the last
coffee was made.
• The coffee is ground too coarsely.
• The coffee is unsuitable.
• The coffee is ground too finely.
MeAnInG
The coffee maker has just
been turned on, the infu-
ser is not inserted correct-
ly and the service door is
not correctly closed.
The pre-ground coffee
funnel is clogged
The infuser has not been
replaced after cleaning.
The inside of the appliance
is very dirty
The service door is open
The coffee maker has
been switched on with the
steam knob in the open
position
soLUtIon
• Warm the cups by rinsing them with hot
water (N.B. you can use the hot water
function).
• Before making coffee, heat the infuser by
pressing the
• Turn the grinding adjustment knob one
click anticlockwise towards "1" while
the coffee mill is in operation (fig. 7).
Continue one click at a time until coffee
delivery is satisfactory. The effect is only
visible after delivering 2 coffees (see the
section: "Adjusting the coffee mill" on
page 11).
• Use pre-ground coffee for espresso
coffee makers
• Turn the grinding adjustment knob
one click clockwise towards "7" while
the coffee mill is in operation (fig. 7).
Continue one click at a time until coffee
delivery is satisfactory. The effect is only
visible after delivering 2 coffees (see the
section: "Adjusting the coffee mill" on
page 11).
19
WHAt to Do
Press the word PUSH on the infu-
ser until it clicks into place.
Make sure the two red buttons
have snapped out.
Close the service door and turn the
appliance on again
Empty the funnel with the help of a
brush as described in the section
"Cleaning the pre-ground coffee
funnel".
Insert the infuser as described in
the paragraph "Cleaning the infu-
ser"
Clean the appliance thoroughly
If you cannot close the door, make
sure the infuser is correctly inser-
ted
Turn the steam knob clockwise un-
til delivery stops
button.