Viewing Messages - Garmin GPS 100 Owner's Manual

hemispheric designation for latitude is either an "N" for North or "S" for South.
If you wish to enter an "N" for North, press the 5 key, which is also labeled
with the letter N. The GPS 100 will automatically display "N" for you.)
To change a cyclic field...
· Press the CLR key.
To indicate approval on a confirmation field...
· Press the ENT key.
To indicate rejection on a confirmation field...
· Press the CLR key.

2.3 VIEWING MESSAGES

From time to time, the GPS 100 will use a message to tell you of conditions
that need your attention. When the GPS 100 has a new message for you,
the Message Annunciator will flash. When this occurs, press the MSG key
to view new message(s). Continue to press the MSG key until the page you
were viewing prior to pressing the MSG key is displayed.
While the Message Annunciator is flashing, the GPS 100 will also generate
an audible tone to alert you of the message. Messages that demand
immediate attention such as an arrival alarm generate a quick tone that will
not stop until you view the message. All other messages generate a slow
tone that will cease after 15 seconds. The message tone may be turned off
if you wish (see Section 11.5 for more information).
Certain messages will remain on the Message Page after being viewed. If
this occurs, the Message Annunciator will be in view but will not flash.
If no messages exist on the Message Page, the Message Annunciator will
MESSAGE PAGE
Message
Annunciator
2-5