Filling With Dishwasher Salt - Baumatic BDWF65W 60cm Instruction Manual

Filling with dishwasher salt

IMPORTANT: You should only use salt that is specially
designed for use in a dishwasher. If any other type of
salt is used in the appliance (in particular table salt),
it will damage the water softener.
o Ideally you should fill the water softener with salt, just before you
are about to run a wash program. This will help to clear any salt
that may have overflowed from the water softener during the salt
filling process.
o Open the door of the dishwasher and then remove the lower
basket. The basket should be empty when you remove it.
o Refit and fully tighten the water softener cap.
o The salt required warning light will go out approximately 2-6 hours
after you have filled the water softener with salt, however the light
may not go out for a few days depending on how much it is used.
When the salt indicator neon lights on the control panel, then you
should follow the filling with dishwasher salt procedure again.
o IMPORTANT: You do not need to pour 500ml of water into
the container when you subsequently fill the water softener
with salt.
o Turn the
anticlockwise and remove it.
o Pour 500ml of water into the water
softener.
IMPORTANT: It is only necessary to do
this when you fill the container with
salt for the first time.
o Pour salt into the water softener, using
the funnel that is supplied with the
appliance. You should add approximately
2 kg of salt into the water softener.
o It is perfectly normal for a small amount
of water to come out of the water
softener, whilst you are filling it with
salt. This does not mean that the water
softener is filled with the correct amount
of salt.
water softener cap
11