Cleaning The Spray Arms; Cleaning The Control Panel - Baumatic BDWF65W 60cm Instruction Manual

IMPORTANT: If a glass gets smashed inside of the appliance,
you must check there is no glass in the filter before the
machine is used again as this can cause a drainage failure.
IMPORTANT: THE DISHWASHER SHOULD NEVER BE
SET ON A WASH CYCLE WITHOUT THE FILTERS BEING
INSIDE OF THE APPLIANCE.

Cleaning the spray arms

The spray arms should be cleaned regularly, to prevent hard water
deposits from clogging the spray arm jets and bearings.

Cleaning the control panel

IMPORTANT: Do not use any abrasive cleaner or household polish on
either the control panel or operating parts.
o Wipe over the control panel using a brand new damp cloth with
warm water.
2. Pull out the main filter and rinse this
under the tap to remove any food debris
that is trapped in it.
3. Place all filters back in their original
position.
4. You must turn the coarse filter clockwise
to lock it back into position.
o To remove the top spray arm,
unscrew the nut and take out
the washer that sits on top of
the spray arm and pull to
remove.
o Gently pull upwards to remove
the bottom spray arm.
o Wash the spray arm in warm,
soapy water and use a soft
brush to clean the jets.
o Rinse the spray arm thoroughly
and then reassemble the spray
arm
position.
back in its original
25