General Troubleshooting - Baumatic BDWF65W 60cm Instruction Manual

General troubleshooting

PROBLEM
Dishwasher Fuse blown or the
doesn't circuit breaker has
run tripped
Power supply is not
switched on
Water pressure is
low
Drain pump Overflow
doesn't stop
Noise Some audible sounds
are normal
Utensils are not
secure in the baskets
or something small
has dropped into the
basket
Motor hums
Suds in the Improper detergent
tub use
Spilled rinse aid
Stained tub Detergent with
interior colourant was used
Dishes are not Rinse aid dispenser
fully dried is empty
POSSIBLE
CAUSES
Replace the fuse or reset the circuit
breaker. Remove any other
appliances that are sharing the same
circuit with the dishwasher.
Make sure that the dishwasher is
turned on and that the door is closed
securely.
Make sure that the power cord is fully
plugged into the wall socket.
Check that the water supply is
connected properly and that the
water is turned on.
The system is designed to detect an
overflow. If it does, then it will run
the drain pump continuously when
there is power to the appliance.
You will get a level of operating noise
during a wash cycle, in particular
when food is being removed from
items and when the detergent
dispenser places the tablet into the
tub.
Ensure that everything is loaded as
per The manufacturer's loading
instructions.
If the dishwasher is not going to be
used for a period of time, then you
should make sure that the appliance
is set on a wash program once a
week. Otherwise the seal around the
motor may dry out and cause noise.
Ensure if you are using 3 in 1
detergent tablets, in conjunction with
rinse aid and salt that the levels are
set correctly.
Always wipe up any excess rinse aid
or rinse aid spillages immediately.
Use a detergent without colourant.
Make sure that the rinse aid
dispenser is filled with rinse aid.
WHAT TO DO
28