Installation Instructions
Cutout for Built-In Oven with
Microwave models only
a Warming Drawer
For JKP90, JTP90, PT970 models only.
27" (68.6 cm) Oven with
Microwave Oven (Model
JKP90) Over a Warming
Drawer
- Over
30" (76.2 cm) Oven with
Microwave Oven (Models
JTP90 and PT970) Over a
Warming Drawer
Anti-Tip
Block
Against Rear
Wall Per
Warming Drawer
Requirement
2" (5,1 cm)
Min.
Anti-Tip Block
Against Rear
Wall Per Warming
Drawer Requirement
2" (5.1 cm)
Min.
Per Warming
Drawer
Requirement
1" (2.5 cm) Min. Above Toekick
Per Warming
Drawer
Requirement
NOTE: Install the
oven only with
specific models
listed on the label
located on top of
the oven.
NOTE: Additional
clearances
between cutouts
may be required.
Check to be sure the oven
supports
above the Warming
Drawer location
do not obstruct the required interior depth and
height,
1" (2.5 cm) Min. Above Toekick
When installing
a Warming
Drawer below
a single or double oven, a separate
120V,
60 Hz, properly grounded
receptacle
must
be installed.
Refer to installation
instructions
packed with the Warming
Drawer for
specific
installation
requirements.
6