GE JKP90 Installation Instructions Manual page 10

Installation Instructions
Preparing for the Bottom
Trim Installation
a. With oven installed, take the bottom trim
and center it on the bottom front edge of
the cabinet opening.
b. Using the trim For27"
(68.6 cm)
models with Lower
as a template, Trim in
Position,
mark the center Mark (2)Mounting
Hole Locations
of each slot
(two total) where
the mounting holes
will be drilled.
c. Remove the trim.
* Remove
d. Drill pilot holes into Lower T rim
Before
the center of each Pre-drilling
template mark.
Mounting
Holes
For 30" (76.2 cm)
models with
Lower Trim in
Position, Mark (2)
Mounting Hole
Locations here
Installing the Metal
Bottom Trim
a.
Place the bottom metal trim centered over
the pre-drilled mounting holes. Tape the
edges of the trim down to maintain the
alignment.
b. Using two trim screws provided, secure
the bottom trim to the bottom edge of the
cabinet.
Trim Screw
Locations for
27" (68.6 cm)
models with
Lower Trim
Side
Side
jTrim
Trim Screw Locations
for 30" (76.2 cm) models
with Lower Trim
IMPORTANT: If this unit is ever
removed from the cabinet or the oven
is ever pulled out for service, the trim
must be removed first or damage to
the trim will occur.
10