Garmin 800 Owner's Manual page 70

Appendix
Problem/Question
I cannot get traffic
information.
The nüvi does not go
into speech recognition
mode.
The nüvi does not
understand my spoken
commands.
Can I use an external
microphone to speak to
my nüvi?
My phone will not
connect to the nüvi.
How do I know my nüvi
is in USB mass storage
mode?

Solution/Answer
Verify that you are in a coverage area. You must be in a coverage
area to get the traffic information for that area.
Verify that the FM TMC Traffic receiver is connected to the power
connector on the cradle and also connected to a power outlet
in your vehicle. (The traffic receiver is included in some nüvi
packages.)
Verify that the remote control is activated
System > Remote >
Replace the battery in the remote control. See
Speak slowly and clearly, and eliminate as much background noise
as possible. Stop conversations, and turn down the radio volume.
Mount the nüvi in your car in a location that is free from excessive
vibrations and away from obvious noise sources.
Yes. In extremely noisy environments, an external microphone can
be used to improve speech recognition performance.
Touch Tools > Settings
is set to Enabled.
Make sure your phone is turned on and is less than 10 meters
(about 33 feet) away from your nüvi.
See www.garmin.com/bluetooth
When your nüvi is in USB mass storage mode, a picture of a nüvi
connected to a computer is shown. Also, you should see two new
removable disk drives listed in
(Tools
Activate New Remote).
> Bluetooth. Verify that the Bluetooth field
for more help.
My Computer.
nüvi 800 Series Owner's Manual
> Settings >
page 4.