Shutdown And Startup Problems - Fujitsu Stylistic Q702 User Manual

Problem
The battery seems to
discharge too quickly.
(continued)

Shutdown and Startup Problems

The Suspend/Resume
switch does not work.
The system powers up and
displays power on informa-
tion, but fails to load the
operating system.
An error message is dis-
played on the screen during
the boot sequence.
Your Hybrid Tablet appears to
change setup parameters
when you start it.
Possible Cause
You're running an application
that uses a lot of power due to
frequent drive access, or use of
wireless devices.
The battery is too hot or too
cold.
Suspend/Resume
switch is disabled.
There may be application soft-
ware. conflict
You have a secured system
requiring a password to load
your operating system.
The boot sequence settings of
the setup utility are not compat-
ible with your configuration.
Hard drive was not detected.
Power On Self Test (POST) has
detected a problem.
BIOS setup changes were not
saved when made and you
exited the setup utility.
Possible Solutions
Use a power adapter for this application when at all possible.
Restore the Hybrid Tablet to normal operating temperature. Charging icon on the Sta-
tus Indicator panel will flash when battery is outside of operating range.
To enable the button, go to Control Panel -> Power Options and click on the Advanced
tab. In the Power buttons area, select the "Change what the power button does"
option.
Close all applications and try the button again.
Make sure you have the right password. Enter the setup utility and verify the Security
settings and modify them as accordingly.
Set the operating source by pressing the [F12] key while the Fujitsu logo is on screen
or use the [F2] key and enter the setup utility and adjust the source settings from the
See "BIOS Setup Utility" on page 39.
Boot menu.
Use BIOS setup utility to auto detect the internal hard drive.
See the Power On Self Test (POST) messages to determine the meaning and severity
of the problem. Not all messages are errors; some are simply status indicators.
"Power On Self Test Messages" on page 62.
Make sure you select Save Changes And Exit when exiting the BIOS setup utility.
60 - Troubleshooting
See "BIOS Setup Utility" on page 39.
See