Fujitsu Stylistic Q702 User Manual page 34

Replacing the Pen Tip
With use, the pen tip may become worn or may pick up foreign
particles that can scratch the screen. A damaged or worn tip may not
move freely, causing unpredictable results when using the pen. If a
problem like this should occur, you should replace the pen tip.
Pull the tip from the barrel.
1
Using one of the new tips that were supplied with your pen,
2
insert the pointed end of the tip into the barrel and push it in
firmly until it is in place
Installing a Pen Tether
To prevent dropping or losing your pen, you should attach
it to your system using the pen tether that is included with
the system.
To attach the pen tether to your Hybrid Tablet, perform the
following steps:
Attach the end of the pen tether with the smaller loop
1
to your pen. To do so, push the end of the tether under
the slot on the top of the pen, then thread the opposite
end of the tether through the loop.
Attach the end of the pen tether with the larger loop to
2
the attachment point on the right side of your tablet.
To do so, insert the end of the pen tether through the
attachment point, then feed the pen through the large
loop in the tether.
33 - Active Digitizer/Touchscreen
Pen Barrel
Figure 16. Replacing the Pen Tip
Figure 17. Installing a Pen Tether
Pen Tip