Starting Your Stylistic Hybrid Tablet; Power On - Fujitsu Stylistic Q702 User Manual

Starting Your STYLISTIC Hybrid Tablet

Power On

Power/Suspend/Resume Switch
The Power/Suspend/Resume switch is used to turn on your STYLISTIC Hybrid Tablet from its off state. Once you have
connected your AC adapter or charged the internal Lithium Polymer battery, you can power on your tablet.
W
HEN YOU TURN ON YOUR
INSTALLED AND CHARGED
To turn on your STYLISTIC Hybrid Tablet from its off state, slide the
Power/Suspend/Resume switch, located on the right side of the
tablet (when the system is held horizontally). When you are done
working you can either leave your Hybrid Tablet in Suspend mode
or you can turn it off. See "Sleep Mode" on page 42 and "Powering
Off" on page 44
.
When you power on your STYLISTIC, it will perform a Power On
Self Test (POST) to check the internal parts and configuration for
correct functionality. If a fault is found, your STYLISTIC Hybrid
Tablet will emit an audio warning and/or an error message will be
displayed. See "Power On Self Test Messages" on page 62.
Depending on the nature of the problem, you may be able to
continue by starting the operating system or by entering the BIOS
setup utility and revising the settings.
After satisfactory completion of the POST, your tablet will load
your operating system.
STYLISTIC H T
YBRID ABLET BE SURE YOU HAVE A POWER SOURCE
, AC A /A
OR THAT THE OR UTO IRLINE ADAPTER IS CONNECTED AND HAS POWER
38 - Starting Your STYLISTIC Hybrid Tablet
. T
HIS MEANS THAT AT LEAST ONE BATTERY IS
.
Figure 20. Power/Suspend/Resume Switch