Feed Stepping Motor - Kenmore 385.190011890 Service Manual

SEVVING MACHINE DIV. 20 MODEL 385.19001890
PARTREMOVAL AND REPLACEMENT
FEEDSTEPPING MOTOR
TO REMOVE:
1. REMOVE THE FRONT COVER (SEE P.24), AND BASE UNIT (SEE P.23).
2. REMOVE THE E-RING (B), AND 2 SCREWS (A).
3. REMOVE THE MOTOR (C) TOGETHER WITH FEED ROD (D).
TO ATrACH:
1. MAKE SURE THE LARGE NOTCH MARK (G) IS IN LINE WITH THE CENTER OF THE PINS IN THE
CONNECTING ARM (E), THEN SLIDE THE FEED ROD (D) ONTO THE FEED ARM PIN (F).
AND THENATTACH THE FEEDSTEPPING MOTOR BY TIGHTNING THE2 SCREWS(A). (TIGHTEN
THE 2 SCREWS AT THE SPOT THAT WHERE THE FEED ARM MOVES SMOOTHLY.)
2. AI-rACH THE E-RING (B).
3. AI-rACH THE BASE AND FRONT COVER.
*AFTERATTACHING THE MOTOR, ADJUST THE "STRETCHSTITCHFEED BALANCE" (SEE P.37),
2 SCREWS (A)
CONNECTING ARM (E)
FEED ROD (D)
FEED STEPPING MOTOR (C)
FEED GEAR _p__ _
E-RING (B)
LARGE NOTCH MARK (G)
/
FEED ARM
PIN (F)
CENTER OF NONNECTING ARM
62