Kenmore 415.162320 Assembly Instructions And Care Manual page 29

Liquid propane gas grill
Table of Contents

Advertisement

Available languages

Available languages

Troubleshooting - Electronic Ignition
SECTION1
Nosparksappearat
any electrodeswhen
ignitionbuttonis
pushed;no noisecan
be heardfrom spark
module,
SECTIONII
Nosparksappearat
any electrodeswhen
ignitionswitchis
pushed;noisecan be
heardfrom spark
module,
SECTIONIll
Sparksare present
butnotat all
electrodesand/ornot
at full strength
, Batterynot installed
properly,
o Deadbattery,
o Buttonassemblynot
installedproperly,
, Faultyspark module,
, Outputlead
connections not
connected,
, Electrodetip not in
properposition,
, Outputlead
connections not
connected.
, Arcingto grillaway
from burner(s),
, Weakbattery,
, Electrodesare wet.
o Electrodescrackedor
broken"sparksat
crack",
, Checkbatteryorientation,
, Has batterybeen used
previously?
, Checkto ensurebutton
assemblyis fully engaged.
Buttonshouldtravel up and
downwithoutbinding.
, If no sparksare generated
with newbatteryand good
wireconnections,moduleis
faulty,
, Are outputconnections on
and tight?
, Are the electrodetips
pointingin the right
direction?Is the gap too big?
, Are outputconnections on
and tight?
, If possible,observegrill in
darklocation,Operate
ignitionsystemand lookfor
arcingbetweenoutputwires
and grill frame,
, All sparkspresentbutweak
or at slow rate,
, Has moistureaccumulated
on electrodeand/orin burner
ports?
, Inspectelectrodesfor
cracks,
o Installbattery(makesure that"-" and "+"
connectors are orientedcorrectly,with "-" end up
and "+" enddown,)
, Replacebatterywith newAAA-sizealkalinebattery,
, Removebuttoncap assembly and reinstall,making
sureit canbe fully engaged,
, Replacespark moduleassembly,
, Removeand reconnectall outputconnections at
moduleand electrodes,
MainBurners:
, Tip of electrodeshouldbe pointingtowardporthole
in burner.The distanceshouldbe 1/8"to 3/16",
Adjustif necessary,
Sideburner:
, Tip of electrodeshouldbe pointingtowardgas port
openingon burner.Thedistanceshouldbe 1/8"to
3/16",Adjustif necessary,
, Removeand reconnectall outputconnections at
moduleand electrodes,
, If sparksare observedotherthanfrom burner(s),
wire insulation may be damaged, R eplacewires,
, Replacebatterywith a newAAA-sizealkaline
battery,
, Use papertowel to removemoisture,
, Replacecrackedor brokenelectrodes,
463363506,29

Advertisement

Table of Contents
loading

Table of Contents