Clean The Shuttle - Kenmore Sears 385.1158180 Owner's Manual

SECTION 5. CARE FOR YOUR MACHINE
o Clean the Shuttle Race
This area must be kept free of dust, lint and occasional tangled thread.
about every three months.
Center pin ot
the shuttle
Lever
case
To Clean the Shuttle Area:
1. Raise the needle bar to its highest
point and remove the bobbin case.
2. Push shuttle race levers aside. Lift
shuttle race cover and take shuttle out.
3. Clean the shuttle race with a lint
brush.
4. Put a drop of oil on the center pm of
the shuttle and shuttle race. Do not
over-oil.
Shuttle driver
Lever_
Shuttle Race L
(Oil here}
Clean the shuttle race area
Lever
Pomted
To Replace Shuttle Assembly:
1.
Shuttle Race
Cover
Posmon shuttle race as illustrated so that shuttle
driver is forming half moon on the left side of the
machine.
2. Hold shuttle by center pin and position shuttle so as
to form a haft moon on the right side, Pointed hook
wili be on the bottom,
3, Place shuttle race cover into place over shuttle
assembly.
4. Snap the levers back into the original position.
29