When The Message "Cannot Staple." Appears; To Clear Jammed Staples - Konica Minolta DI2510 Advanced Information

Touch Panel Messages
12.5

When the Message "Cannot Staple." Appears

To clear jammed staples

When a finisher is installed and the staples are jammed, the message
shown below appears.
Follow the procedure described below to clear the jammed staples.
Follow the procedure described below to remove the paper and staples.
Note
When the message "Cannot Staple." appears, clear the jammed
staples as described below.
Not following the following procedure and forcefully pulling out the
paper may result in damage to the "Stapler Unit".
1
Remove all paper from the finisher.
Di2510/Di3010/Di3510
12
12-27