Loading Paper Into The Multiple Bypass Tray; To Load Plain Paper - Konica Minolta DI2510 Advanced Information

9

Loading Paper Into the Multiple Bypass Tray

Use the multiple bypass tray when printing on plain paper, postcards,
envelopes, overhead projector transparencies and label sheets.
Copying onto the lower side of the set paper.
Note
To set paper other than plain paper, settings must be made in the
panel.
While a copy job is being printed or queued, the paper size for the
multiple bypass tray cannot be set.
In addition, the "OHP Interleaving" function cannot be set at the same
time.

To load plain paper

1
Open the multiple bypass tray.
When loading large-sized paper,
open the tray extension.
2
Adjust the paper guides to fit the
size of the paper, and then insert
the paper as much as possible into
the feed slot.
Note
Do not load so much paper that
the top of the stack is higher
than the Ä mark.
Make sure that the paper guides are pushed up against the edges
of the paper.
9-10
Copy Paper
Tray extension
Paper guides
Di2510/Di3010/Di3510