Making Front-Panel Settings; Changing Hdmi Settings; Removing The User Settings Menus - Pace RNG110 Operator's Manual

MAKING USER SETTINGS (cont.)

Making Front-Panel Settings

You can use the Front Panel Settings menu to set the brightness level of the front-panel lights when your
set-top is being used ("Viewing Brightness") and when it is switched off ("Standby Brightness").
If you have not done so already, put your set-top into User Settings mode, as described on page 11.
1. Press the U or D button on your remote control and highlight Front Panel Settings on the PACE USER
SETTINGS menu.
2. Press the R button. The Front Panel Settings menu, shown right, appears on your TV screen.
3. Press the U or D button to highlight "Standby Brightness" or "Viewing Brightness" as required.
4. Use the OK/Select button to choose the setting you want (the setting changes each time you press OK/
Select): "Low", "Std" (Standard), or "High". Look at the dimming and brightening of the front-panel lights
while you are making the settings, to see the effect of your selections.
5. When you have made all the changes you want to make, press L to redisplay the PACE USER SETTINGS
menu.

Changing HDMI Settings

You can use the HDMI Settings menu to choose an Audio Output Mode, and to enable or disable automatic
detection of a newly connected HDTV (when using an HDMI cable).
If you have not done so already, put your set-top into User Settings mode, as described on page 11.
1. Press the U or D button on your remote control and highlight HDMI Settings on the PACE USER
SETTINGS menu.
2. Press the R button. The HDMI Settings menu, shown right, appears.
3. Press the U or D button to highlight "Audio Output Mode" or "Disable Auto Detect" as required.
4. Use the OK/Select button to choose the setting you want (the setting changes each time you press OK/
Select).
Audio Output Mode has three possible settings:
"Auto" (provides the audio format best suited to the connected equipment)
"L-PCM" (provides PCM audio only)
"Pass Through" (maintains the original incoming-audio format)
Disable Auto Detect is either "YES" or "NO".
5. When you have made all the changes you want to make, press L to redisplay the PACE USER SETTINGS
menu.

Removing the User Settings menus

When you have finished making all the user settings you wish to make, press the POWER button to remove
the PACE USER SETTINGS menu and return to normal viewing.
RNG110 OPERATOR'S MANUAL (501-3438000)
Front Panel Settings
Standby Brightness : Std
Viewing Brightness : High
HDMI Settings
Audio Output Mode : Auto
Disable Auto Detect : NO
15