Making Front-Panel Settings - Pace TDC787X Operator's Manual

MAKING USER SETTINGS (cont.)
3 If you wish to reset all the Closed Caption settings to their default values (mainly Auto), press the D button to
highlight "Reset to Defaults" on the menu, then press SELECT.
4. When you have made all the changes you want, press L twice to redisplay the PACE USER SETTINGS menu.

Making Front-Panel Settings

You can use the Front Panel Settings menu to set the brightness level of the front-panel lights (but not the
POWER light) when your set-top is being used ("Viewing Brightness") and when it is switched off ("Standby
Brightness").
In the front panel of your set-top is an IR (infrared) receiver, which reacts when you press buttons on your remote
control. You can use the Front Panel Settings menu to turn this IR receiver off. Generally, you should leave it set to
"On", but you may wish to turn it off if you have a plasma HDTV that causes interference with your remote control.
If you turn it off but still wish to control your set-top by remote control, you must connect a "remote eye"
(IR tether) to the IR RECEIVE connector on your set-top's rear panel and place the remote eye away from your
HDTV. If you have no remote eye, and "IR Receiver" is set to "Off", the only way to control your set-top is to use
the front-panel buttons.
If you have not done so already, put your set-top into User Settings mode, as described on page 23.
1. Press the U or D button until the front panel shows "FP".
On the PACE USER SETTINGS menu, Front Panel Settings is highlighted when "FP" is on the front panel.
2. Press the R button. The Front Panel Settings menu, shown right, appears on your TV screen.
3. Press the U or D button to highlight "Standby Brightness" and "Viewing Brightness" in turn, as required.
4. For each level, use the SELECT button to choose the setting you want: "Low", "Std" (Standard), or "High"
(the setting changes each time you press SELECT). Look at the dimming and brightening of the front-panel
lights while you are making the settings, to see the effect of your selections.
Front Panel Settings
Standby Brightness : Std
Viewing Brightness : High
IR Receiver : On
31