Making User Settings; About User Settings; About The Tv Aspect Ratio - Pace RNG110 Operator's Manual

MAKING USER SETTINGS

About User Settings

Your installer should have made the correct settings so that your set-top is compatible with your HDTV or TV.
However, you may wish to change some settings, for example if you purchase a new HDTV. You can make the
following settings and you can also reset them to the factory defaults.
• TV Aspect Ratio (the screen's width-to-height ratio, or shape)
• TV Display Capability (screen resolution)
• Auto Pillarbox
• Closed Captions
• Front Panel Settings
• HDMI Settings
You use the buttons on your remote control to make the settings using on-screen menus. However, until your
set-top has been set up to match the display capability of your TV (see page 12), these menus may not be
visible.
Putting your set-top into User Settings mode
1. Make sure that your set-top is turned on (POWER light is green).
2. Press the POWER button on your remote control (POWER light goes off), then press the MENU button.
You should see the PACE USER SETTINGS menu, shown right, on your TV screen.
3. When you have finished making changes (see pages 11 through 15), press the POWER button to remove the
PACE USER SETTINGS menu and return to normal viewing.

About the TV Aspect Ratio

The TV that you have connected to your set-top has an aspect ratio (width-to-height ratio) of 4:3 (basic/
standard) or 16:9 (widescreen). You must set the appropriate TV Aspect Ratio (4:3 or 16:9) on your set-top, so
that it is compatible with your TV.
Setting the TV Aspect Ratio
If you have not done so already, put your set-top into User Settings mode, as described above.
Press the U or D button on your remote control and highlight TV Aspect Ratio on the PACE USER SETTINGS
menu.
1. Press the U or D button on your remote control and highlight TV Aspect Ratio on the PACE USER
SETTINGS menu.
2. Press the R button.
The TV Aspect Ratio menu, shown below, appears on your TV screen. On the menu, the current setting
("4:3" or "16:9") has > in front of it. Also, whenever the current setting is displayed, the DATA light will be
lighted on your set-top's front panel.
3. Press the U or D button to highlight the TV Aspect Ratio you want.
4. Press the OK/Select button to confirm your choice and change to that TV Aspect Ratio.
5. Press the L button. The PACE USER SETTINGS menu reappears.
To continue making the settings, see the next section.
TV Aspect Ratio
4:3
>16:9
RNG110 OPERATOR'S MANUAL (501-3438000)
POWER light
PACE USER SETTINGS
TV Aspect Ratio
TV Display Capability
Auto Pillarbox
Closed Captions
Front Panel Settings
HDMI Settings
Restore Defaults
Select[OK] Exit[POWER]
4:3 standard TV,
EDTV or HDTV
16:9 HDTV
11