Making Hdmi Settings; Removing The User Settings Menus - Pace DC700X Operator's Manual

Hide thumbs Also See for DC700X:

Table of Contents

MAKING USER SETTINGS (cont.)

Making HDMI Settings

You can use the HDMI Settings menu to choose an Audio Output Mode, and to enable or disable automatic

detection of a newly connected HDTV (if it is connected by an HDMI cable).

If you have not done so already, put your set-top into User Settings mode, as described on page 22.

1. Press the U or D button on your remote control and highlight HDMI Settings on the PACE USER SETTINGS

menu.

2. Press the R button.

The HDMI Settings menu appears (see right).

3. Press the U or D button to highlight "Audio Output Mode" or "Disable Auto Detect" as required.

4. Use the SELECT button to choose the setting you want (the setting changes each time you press SELECT).

Audio Output Mode has three possible settings:

"Auto" (provides the audio format best suited to the connected equipment)

"L-PCM" (provides PCM audio only)

"Pass Through" (does not change the audio format)

Disable Auto Detect is either "YES" or "NO".

5. When you have made all the changes you want, press L to redisplay the PACE USER SETTINGS menu.

When you have finished making all the user settings you wish to make, press the POWER button to remove the

PACE USER SETTINGS menu and return to normal viewing.

HDMI Settings

Audio Output Mode : Auto

Disable Auto Detect : NO

Table of Contents