Table of Contents
Advertisement
Four
Screws
--
Quatre
vis
Cuatro
Lay unit on floor bottom up with
nozzle flat.
Install
the four screws
to the nozzle
cover.
Route nozzle hose to hose holder.
Align nozzle hose bracket with
retaining bracket on body and slide
down unit it clicks into place.
Return the vacuum cleaner to the
upright position before plugging
into an electrical outlet.
Cleaning
Agitator
I
\
Clean agitator after every five uses
and every time the belt is replaced.
Remove lower plate. (See
REPLACING
BELT, p. 42, 44)
Cut off any hair, thread, string,
carpet pile, and lint entangled
around agitator with a pair of
scissors.
Remove agitator. (See REPLACING
BELT, p. 44)
Remove any string or debris located
on the end caps, washers or agitator
shaft.
Reinstall agitator and lower plate.
(See REPLACING BELT, p. 44)
- 46 -
Advertisement
Table of Contents
