Chapter 2. Options; Chapter 3. Master Reset And Program Reset - Sharp XE-A203 - Cash Register Thermal Printing Graphic Logo Creation Service Manual

[Display sample]
" 0.00": Battery is OK.
"L 0.00": Low battery (You have to change the batteries.)
" 0.00": No battery (You have to change the batteries immediately.)
L
After finalization
"F 12.34": Battery is OK.
"L 12.34": Low battery. ("L" indicate instead of "F".)
" 12.34": No battery. ("L" indicate instead of "F".)
L
Note: "NO BATTERY": When the "NO BATTERY" is display, the mas-
ter reset is executed at the timing of "POWER
ON" after the "POWER OFF".

CHAPTER 2. OPTIONS

1. OPTIONS (NONE)
2. SERVICE OPTIONS (NONE)
3. SUPPLIES
NO NAME
1 Thermal roll paper
4. SPECIAL SERVICE TOOLS
NO NAME
1 USB Cable

CHAPTER 3. MASTER RESET AND PROGRAM RESET

1. MASTER RESETTING
Master resetting clears the entire memory and resumes initial values.
Master resetting can be accomplished by using the following procedure:
Procedure A: 1) Unplug the AC cord from the wall outlet or set the
mode switch to OFF Position.
2) Let the ECR be without the memory back up battery.
3) Wait over 1 muinite for discharging.
4) Set the mode switch to any position except OFF.
5) Plugin the AC cord to the wall outlet or turn the
mode switch from OFF Position to another position.
The master reset can also be accomplished in the following case.
In case power failure occurs when the machine has no battery
attached to it, the master reset operation is automatically performed
after the power has been restored.
(This is because if power failure occurs with no battery attached to
the machine, all the memories are lost and the machine does not
work properly after power recovery; this requires the master reset
operation.)
10. SD MEMORY CARD
[Device]
SD Card (Version. 1.01)
[Outline]
XE-A203U has a SD Memory Card slot.
[Specidications]
1) Variable clock rate
2) Other commands and memory access : 2.7 - 3.6V
3) Bus Protocol
4) Correspondence capacity
5) Recommended manufacturer
PARTS CODE
TPAPR6656RC05
PARTS CODE
2. PROGRAM RESETTING
(INITIALIZATION)
This resetting resumes the initial program without clearing memory.
This resetting can be operated at below sequence in PGM mode.
Procedure:
Note: In case power failure occurs when the machine has no battery
attached to it, the master reset operation is automatically
performed after the power has been restored.
XE-A203U/XE-A203A OPTIONS
– 5 –
: 0 - 25 MHZ
: SPI Bus
: 32MB - 512MB
: SanDisk
PRICERANK DESCRIPTION
BA 5 ROLLS/PACK
PRICE RANK DESCRIPTION
1) Unplug the AC cord from the wall outlet.
2) Wait over 1 muinite for discharging.
3) Set the mode switch to the PGM position.
4) While holding down the FEED key, plugin the AC
cord to the wall outlet.