Port Type: (Select
one of either
Ethernet or Token
Ring)
From the Configure menu, select Route Selection. Then:
5
Configure the following.
Prompt:
Entry Number:
Address:
#1 Destination:
From the Configure menu, select Mnemonic table. Then:
6
Configure the following.
Prompt:
Entry Number:
Mnemonic name:
Call parameters:
Follow these steps to configure Node 300 as shown in Figure 3-3.
ETH
Identifies an
Ethernet interface
port.
TR
Identifies a Token
Ring interface port.
Enter:
Result/Description
1
References this
table record.
100*
Identifies the
address to be
routed.
P1
Identifies Port 1 of
this node.
Enter:
Result/Description
1
References this
table record.
LAN100
Identifies the
mnemonic name.
10094
Identifies the
location to send the
autocall to. The
convention is to
identify the node
and port number in
this parameter.
The Route
Selection table
appears.
The Mnemonic
table appears.