Msi; Msi Check Character; Msi Message Length - Honeywell 2020-5 User Manual

MSI

<Default All MSI Settings>
MSI
On
* Off

MSI Check Character

Different types of check characters are used with MSI bar codes. You can
program the image scanner to read MSI bar codes with Type 10 check
characters. Default = Validate Type 10, but Don't Transmit.
When Check Character is set to Validate and Transmit , the image scanner will
only read MSI bar codes printed with the specified type check character, and will
transmit this character at the end of the scanned data.
When Check Character is set to Validate, but Don't Transmit , the unit will only
read MSI bar codes printed with the specified type check character, but will not
transmit the check character with the scanned data.
* Validate Type 10, but Don't
Transmit
Validate Type 10 and Transmit

MSI Message Length

Scan the bar codes below to change the message length. Refer to Message
Length on page 6-2 for additional information. Minimum and Maximum
lengths = 4-48. Minimum Default = 4, Maximum Default = 48.
Minimum Message Length
Maximum Message Length
6 - 27