Chapter 5 - Data Formatting; Data Format Editor Introduction; To Add A Data Format - Honeywell 2020-5 User Manual

5
Data Formatting

Data Format Editor Introduction

You may use the Data Format Editor to change the image scanner's output. For
example, you can use the Data Format Editor to insert characters at certain
points in bar code data as it is scanned. The selections in the following pages
are used only if you wish to alter the output. Default Data Format setting =
None.
Normally, when you scan a bar code, it is output automatically; however when
you do a format, you must use a "send" command (see
page 5-2) within the format program to output data.
Multiple formats may be programmed into the image scanner. They are stacked
in the order in which they are entered. However, the following list presents the
order in which formats are applied:
1. Specific Term ID, Actual Code ID, Actual Length
2. Specific Term ID, Actual Code ID, Universal Length
3. Specific Term ID, Universal Code ID, Actual Length
4. Specific Term ID, Universal Code ID, Universal Length
5. Universal Term ID, Actual Code ID, Actual Length
6. Universal Term ID, Actual Code ID, Universal Length
7. Universal Term ID, Universal Code ID, Actual Length
8. Universal Term ID, Universal Code ID, Universal Length
If you have changed data format settings, and wish to clear all formats and
return to the factory defaults, scan the Default Data Format code on

To Add a Data Format

Step 1. Scan the Enter Data Format symbol
Step 2. Primary/Alternate Format
Determine if this will be your primary data format, or one of 3 alternate
formats. (Alternate formats allow you "single shot" capability to scan
one bar code using a different data format. After the one bar code has
been read, the image scanner reverts to the primary data format. See
page
Programming Chart
programming an alternate format, scan 1, 2, or 3, depending on the
alternate format you are programming.
Step 3. Terminal Type
Refer to the Supported Terminals Chart
minal ID number for your PC. Scan three numeric bar codes on the
inside back cover to program the image scanner for your terminal ID
(you must enter 3 digits). For example, scan 0 0 3 for an AT wedge.
Note: The wildcard for all terminal types is 099.
5-5.) If you are programming the primary format, scan 0 using the
inside the back cover of this manual. If you are
Send Commands
(page 5-4).
(page 2-2) and locate the Ter-
on
page 5-4.
5 - 1