Chapter 8 - Utilities; To Add A Test Code I.d. Prefix To All Symbologies; Reset Image Scanner; Show Software Revision - Honeywell 2020-5 User Manual

8
Utilities

To Add a Test Code I.D. Prefix to All Symbologies

This selection allows you to turn on transmission of a Code I.D. before the
decoded symbology. (See the Symbology Chart, page A-1) for the single char-
acter code that identifies each symbology.) This action first clears all current
prefixes, then programs a Code I.D. prefix for all symbologies. This is a tempo-
rary setting that will be removed when the unit is reset. For instructions on how
to reset your image scanner, refer to

Reset Image Scanner

(page 8-1).
Add Code I.D. Prefix to
All Symbologies (Temporary)
Reset Image Scanner
Scanning this bar code causes the image scanner to re-link with the base.
Reset Imager

Show Software Revision

Scan the bar code below to output the current software revision, unit serial num-
ber, and other product information for both the image scanner and base.
Show Revision

Show Data Format

Scan the bar code below to show current data format settings.
Data Format Settings
8 - 1