Furuno FM-4000 Owner's Manual page 48

want to communicate on, then press the [ ENT ]
key.
6. Press the [ ENT ] key again to transmit the Group
call signal.
7. When the Group call signal is sent, the LCD
displays the information shown in the illustra-
tion at right.
8. After the Group call is transmitted, all the ra-
dios in the group switch to the designated chan-
nel.
9. Listen to the channel to make sure it is not busy,
then key the microphone and call the other ves-
sels you desire to communicate with.
Manual Calling
You may enter a Group MMSI number manually to contact a group whose
Group call number is not registered in the radio.
1. Press the [ CALL ( MENU )] key to show the "DSC
Call Menu Call Menu
Call Menu Call Menu Call Menu."
2. Turn the CHANNEL selector knob to select
Group." (To cancel, press the [ CLR ] key.)
"Group
Group Group
Group
3. Press the [ ENT ] key. The transceiver beeps
then the "Group Directory" appears.
4. Turn the CHANNEL selector knob to select
Manual," then press the [ ENT ] key.
"Manual
Manual Manual
Manual
5. Enter the MMSI number (nine digits: first digit per-
manently set to "0") which you want to contact, then
press the [ ENT ] key.
6. If you enter a wrong number in the MMSI number,
press the [ H/L ] key until the wrong number is se-
lected, then enter the correct number.
7. When you have finished entering the MMSI
number, press and hold the [ ENT ] key.
8. Turn the CHANNEL selector knob to select
," then press the [ ENT ] key.
" Manual Manual Manual
Manual Manual
9. Turn the CHANNEL selector knob to select the op-
erating channel you want to communicate on, then
press the [ ENT ] key.
10. Press the [ ENT ] key again to transmit the Group
call signal.
Page 48
DSC DSC DSC DSC
FM-4000