Table of Contents
Advertisement
Caution:
Never use paper in the sheet feeder with thickness outside
the range 0.07 mm - 0.10 mm (0.003" - 0.004") in
automatic feed mode. In manual feed mode, never use
paper whose thickness is outside the range 0.07 mm - 0.23
mm (0.003" - 0.01"). Doing so may cause paper jams or
damage to the printer.
Paper jams can be caused by feeding in paper that is
extremely smooth or shiny, too rough, or paper that
easily picks up static electricity. Paper jams and other
paper feed problems can tear the ribbons in ink
cartridges.
To avoid such problems, please note the following
precautions:
•
Always use the recommended paper types, and
be sure to set the printer's paper options properly.
Settings that are not appropriate for the paper
being used can cause paper jams.
•
When printing on a thick sheet, or an irregular
postcard-size sheet allow a 1/2 inch (12 mm)
margin on the left and right side to prevent
printing over the paper edge, this could result in
tearing the ink cartridge ribbon.
Chapter 2 - Initial Setup
•
When printing on used sheets (already printed on
the same side), use manual feed only. Automatic
feed may not feed used sheets properly. When
using manual feed, avoid repeatedly inserting and
removing the same sheet.
Loading paper in automatic feed mode
Use automatic feed mode for continuous printing.
There are two methods for loading paper, depending on
the media.
Loading high grade/laser paper and Press
Papers
1.
Pull the paper support upwards.
English
25
Advertisement
Table of Contents
Troubleshooting
