Zoom In After Find; Coordinate Display Format; Cockpit Layout; Backlight Settings - Audiovox NVX225 - Automotive GPS Receiver User Manual

Gps navigation software for audiovox nvx225

Hide thumbs Also See for NVX225 - Automotive GPS Receiver:

Table of Contents

5.6.1.3

Zoom in after find

When this switch is turned off, The NVX225 Navigator will centre the map to the

location selected in Find but will not change the zoom level. If you turn this switch on,

The NVX225 Navigator will also zoom in to the selected point.

The zoom level in this case depends on the type of object you have searched for. For

example in the case of a city search, the zoom level will show you the whole

settlement or at least a significant part of it around its centre. Selecting POI, a

junction or an exact address will give you a closer look with only a few streets on the

display.

5.6.1.4

Positions are sometimes displayed with their addresses, and sometimes with their

coordinates. This setting lets you choose between displaying coordinates in degrees

(dd.dddddd); degrees and minutes (dd mm.mmm); or degrees, minutes and seconds

(dd mm ss.s).

Note: the coordinate display mode is independent from the coordinate input in Find

menu. You can use all three formats freely on the coordinate input screen.

5.6.1.5

There are three route data fields at the bottom of the Cockpit screen. Their content is

fixed in Cruise mode (when there is no active route), but for Navigation mode you

can change their content here. The available values are listed in 4.5.15.

Here you can set how the PND backlight behaves when using The NVX225

Navigator.

5.6.2.1

At the top of the screen you can set how the backlight will behave when the screen

has not been touched for a while.

Backlight always on

You can choose to have the lights always on.

Table of Contents