Craftsman 137.375640 Operator's Manual page 34

BEFORE LEAVING THESAW
o Never l eave toolrunning unattended.
Turnpower OFF. W aitforallmoving
partstostop.
o Makeworkshop c hildproof. Lockthe
shop.Disconnect master s witches.
Store toolawayfromchildren and
otherunqualified users.
[,_WARNING ]
To avoid injury from materials being
thrown, always unplug the saw
to avoid accidental starting, and
remove small pieces of material
from the table cavity.
REVEL CUT (FIG. DD)
1. When a bevel cut is required, loosen
the bevel lock handle (1) by turning
it clockwise.
2. Tilt the cutting head to the desired
angle, as shown on the bevel
scale (2).
3. The blade can be positioned at any
angle, from a 90 ° straight cut (0 ° on
the scale) to a 45 ° left/right bevel.
Tighten the lock handle (1) to lock
the cutting head in position. Positive
bevel stops are provided at 0 ° and
45 °"
Fig. DD
MITER CUT (FIG. CC)
1. When a miter cut is required, unlock
the miter table by releasing the miter
lock lever (1).
2. While holding the miter handle (2),
press down on the positive stop
locking lever (3).
3. Rotate the miter table to the right or
left with the miter handle.
4. When the table is in the desired
position, as shown on the miter
scale (4), release the positive stop
locking lever and tighten the miter
handle. The table is now locked at
the desired angle. Positive stops are
provided at 0°, 15°, 22.5 °, 31.6 ° and
45 °"
iMPORTANT: Always lock the miter
lock lever before performing a cut.
Fig. CC
33.9 ° CROWN MOULDING (FIG. EE)
NOTE: When cutting crown moulding,
the bevel angle should be set 33.9 °
right or left.
1. Loosen the bevel lock handle (1),
2. Rotate the bevel stop block (2) and
set bevel angle at the 33.9 ° position.
3. Tilt the cutting arm to the left or right.
Fig. EE
33.9 °
2