Craftsman 137.375640 Operator's Manual page 18

[_,WARNING]
To avoid injury, do not connect
this miter saw to the power source
until it is completely assembled and
adjusted and you have read and
understood this Operator's Manual.
INSTALLING THE MITER HANDLE
(FIG.A)
1. Thread the miter handle (1) into the
hole (2) located at the front of the
miter table.
Fig. A
1
2. Pull out the stop latch knob (2).
3. Allow the cutting head to rise to the up
position.
Locking
When transporting or storing the miter
saw, the cutting head should always be
locked in the down position.
1. Push the cutting head down to its
lowest position.
2. Push the stop latch knob (2) into the
locking hole.
Fig. B
IAWARNING]
o To avoid injury and damage to
the saw, transport or store the
miter saw with the cutting head
locked in the down position.
Never use the stop latch to
hold the cutting head in a down
position for cutting operations.
o To avoid damage, never carry
the miter saw by the switch
handle, the cutting arm or the
miter table handle. Always use
the designated carrying handle.
CUTTING HEAD (FIG. B)
Raising
1. Push down slightly on the switch
handle (1).
iNSTALLING THE DUST BAG (FIG. C)
1. Squeeze the metal collar wings (1)
of the dust bag (2).
2. Place the dust bag neck opening
around the exhaust port (3), and
release the metal collar wings.
Fig. C
2
\